Optimal bus fleet management strategy for emissions reduction

Transportation is a major cause for environmental degradation via exhaust emissions. For many transit-oriented metropolitan areas, bus trips often constitute a sizeable mode share. Managing the bus fleet, in particular updating buses to comply with the newer emissions standards, therefore, can have a substantial impact on transportation-induced air quality. This paper presents the approach of remaining life additional benefit–cost (RLABC) analysis for maximising the total net benefit by either early-retiring or retrofitting the current bus fleet within their lifespans. By referring to the net benefits for different bus types estimated by RLABC analysis, the most beneficial management scheme for the current bus fleet can be identified. Optimal bus fleet management (BFM) models based on the RLABC analysis for the operator and the government are developed. Then a government subsidy plan is produced to achieve win–win solutions, which will offer efficient and flexible management schemes. To illustrate the approach, the largest bus company in Hong Kong, which carries more than 23% of the total trips in Hong Kong, is taken as a case study example. Instead of adopting a fixed retirement plan, such as replacing buses at the age of 17 as is currently practised, the proposed method develops an optimal BFM scheme that progressively phases out buses or retrofits them. This study produces promising results to demonstrate the large benefit of this approach for optimal bus fleet management.     

垃圾土力学特性及其路基填筑应用研究

将垃圾土应用于公路路基填筑是实现垃圾土大规模资源化利用的有效途径。本文首先对实际垃圾土进行筛分处理,制得适用于公路路基的垃圾筛余土(简称垃圾土);进而,通过室内试验研究了直接压实垃圾土和固化垃圾土的抗剪强度、CBR值等力学特性;以此为基础,修筑直接压实垃圾土路基试验段,并采用适宜的新型施工工艺修筑固化垃圾土路基试验段,监测路基的工后沉降随时间的变化规律,对比两种垃圾土路基的应用效果。结果表明:固化垃圾土与直接压实垃圾土相比,粘聚力提高1.6~1.9倍,内摩擦角提高30%以上,CBR值提高4.5~5.1倍;固化垃圾土路基的工后沉降比直接压实垃圾土路基降低64.7%,且能够更早地趋于稳定。以上结果证明:本文提出的固化垃圾土路基施工工艺和垃圾土资源化利用途径是可行的。     

船体板格极限强度数值计算影响因素及敏感分析

船体板格极限强度的有限元计算方法应用广泛,但其计算方法具有一定的不稳定性,计算结果受多种因素的影响.本文针对船体板格有限元计算方法的不稳定性进行研究,通过将有限元计算结果与其他学者的研究成果进行对比,验证本文所采用的有限元方法的可靠性,然后针对板格材料、初始缺陷、网格密度、边界条件等几种因素的敏感性进行具体研究,发现理想应力应变关系会使得结果偏于危险.网格形状和网格密度对于结果均有影响,边界条件对于有限元结果有影响,最大误差在7.2%,并且模型3会使得结果偏于危险.初始缺陷是一敏感因素,最大误差在20%,因此需要根据实际缺陷选取合适的屈曲模态和比例因子.     

基于一个二维水弹塑性方法和极限强度评估的集装箱船结构优化研究

海上极端波过去常常导致船舶结构的极限破坏,而船舶的极限崩溃涉及到船体结构的动态极限强度和结构非线性.该文通过二维的水弹塑性方法研究了集装箱船在极端波中的非线性动态强度,该方法考虑了船体的极限强度以及船体结构的非线性和波浪之间的耦合.并通过该二维水弹塑性方法和极限评估方法研究了船体结构的结构优化.文中还通过二次规划法(SQP)来优化基于非线性的动态强度的集装箱船体结构.最少的结构成本是本优化的目标函数,约束条件保证船体的强度要小于结构的极限强度,并且结构设计尺寸要满足规范的要求.随着设计波高的变化,这些优化的设计变量的变化趋势得以发现,一些研究的结论可用于船舶规范的参考.     

斜向波浪对斜坡堤胸墙作用力的试验研究

斜坡堤胸墙的稳定性主要受到波浪作用的影响,而且实际工程中斜坡堤多受斜向波浪作用。通过斜向与正向不规则波对斜坡堤胸墙作用的物理模型试验研究,分析斜坡堤单个胸墙所受的斜向波浪总力的折减系数随水位和波浪入射角度的变化规律,并与斜向波浪对单元直立堤的作用情况进行对比。结果表明:斜坡堤单个胸墙所受的斜向波浪总力的折减系数总体上随着水位的降低而变小,随着波浪入射角度的减小而变小;斜向波浪总浮托力的折减系数一般小于总水平力的折减系数;在不同水位和波浪入射角下,斜坡堤单个胸墙所受的斜向波浪总力的折减系数与单元直立堤有一定差别。     

Assessment of fatigue strength of steel butt-welded joints in as-welded condition – Alternative approaches for curve fitting and mean stress effect analysis

Experimental fatigue data for butt-welded joints in as-welded condition and under constant amplitude tensile loading (secondary bending included) were analyzed using the nominal stress system and the notch stress system. Two approaches were used; a standard fitting procedure and minimization of the sum of squared perpendicular distances from a line with a fixed and free slope. In all cases, the latter method gave better agreement between the experimental and predicted fatigue life and fatigue strength. The analyses showed both with all broken specimen data included and with reduced data that the FAT225 curve, as recommended by IIW, might be too optimistic for the notch stress approach in the case of butt-welded joints in as-welded condition. It was also found that use of the local stress ratio instead of the applied stress ratio might explain many issues concerning current observations and apparent inconsistencies in reported literature.     

北方地区高等级公路中央分隔带防眩设施的几种典型应用方式的比较

通过对辽宁等北方省份高等级公路中分带防眩设施的几种典型应用方式的比较,详细分析了每种中分带防眩设施的优缺点,提出了中分带防眩设施选型需要考虑的防眩、景观、投资等多种因素,为项目决策单位提供详实的依据。     

Subjective-utility travel time budget modeling in the stochastic traffic network assignment

ABSTRACT

In this article, we propose a new model called subjective-utility travel time budget (SU-TTB) model to capture travelers' risk-averse route choices. In the travel time budget (TTB) and mean-excess travel time (METT) model, a predefined confidence level is needed to capture the risk-aversion in route choice. Due to the day-to-day route travel time variations, the exact confidence level is hard to be predicted. With the SU-TTB model, we assume travelers' confidence level belongs to an interval that they may comply with in the route choice. The two main components of SU-TTB are the utility function and the TTB model. We can show that the SU-TTB can be reduced to the TTB and METT model with proper utility function for the confidence levels. We can also prove its equivalence with our recently proposed nonlinear-expectation route travel time (NERTT) model in some cases and give some new interpretation on the NERTT with this equivalence. Finally, we formulate the SU-TTB model as a variational inequality (VI) problem to model the risk-averse user equilibrium (RAUE), termed as generalized RAUE (GRAUE). The GRAUE is solved via a heuristic gradient projection algorithm, and the model and solution algorithm are demonstrated with the Braess's traffic network and the Nguyen and Dupuis's traffic network.     

基于地基回弹因素的盾构隧道管片上浮预测

针对软弱地层盾构隧道管片脱出盾尾后出现的上浮问题,分析盾构施工过程中管片上浮的诱因,得出软弱地层中管片的上浮主要是地层应力重分布产生的地基回弹力引起的。在此基础上建立隧道开挖动态模型,分析隧道上浮量变化规律以及地层特性对管片上浮量的影响规律,得出地层弹性模量和管片上浮量呈一定的指数关系,且弹性模量对管片上浮量的影响远大于地层黏聚力和内摩擦角。通过力平衡理论计算盾构开挖引起的地层回弹力、管片上浮量以及隧道上浮影响的地层高度范围,并通过对珠江狮子洋工程管片上浮量的计算与实测对比,证明该公式的合理性,为盾构隧道工程中考虑地基抗力引起的管片上浮量预测提供一种新的方法。     

面向控制的SCR催化转化器温度模型

为了建立面向控制的SCR催化器温度模型,根据能量守恒和质量守恒方程并考虑热平衡中所涉及的换热过程不同,建立了4种SCR催化器温度的数学模型,并利用Matlab/Simulink构建图形化的计算模型。采用柴油机欧洲稳态循环(ESC)和欧洲瞬态循环(ETC)条件下的台架实测数据对模型进行检验,基于最大离散程度、拟合度和计算时间3个指标对模型进行评价和比较。结果表明,考虑催化器与废气和周围环境对流换热的温度模型具有良好的预测精度和实时性,更适合用于SCR控制策略。